Repair

CUSTOMER NAME

PERSON TO BE CONTACTED

ADDRESS

City

Province or State

Country

Zip Code

Date of Pick up

Invoice #

THE FOLLOWING HANDPIECES ARE ENCLOSED FOR REPAIR

Hint: Please enter between 80 - 300 characters.

Water Spray not working Not torque on hand piece Chuck does not hold bur

Rotor making a lot of noise Light not working Bur speed too slow

Shipping and service charges will be applied if the described problems are not valid. The original invoice has to be attached in order for the warranty to be valid.

Maintenance Steps for High Speed Handpieces

1.Prior to removing from hose, run handpiece for 10 seconds.
2.Clean externally with a degreaser/cleaner. NEVER USE SOAP OR WATER! High heat cause soap to crystallize, causing bearings to seize, water causes rust deposits internally!
3.Apply 3-5 drops of handpiece lubricant to intake side of handpiece (shown above). Please use a low viscosity lube.

IF LUBE DOES NOT EXPEL FROM HEAD CLEAR AND CLEAN REPEAT THE PROCEDURE

4.Remove bur, bag handpiece. Make sure to elevate the head, so that sediments may run down the tube rather than rest in bearings where they may cause rust deposits.

Do Not Use Dry Heat, Which May Damage Internal Parts.

5.Upon completion of sterilization cycle, open bag to air dry..

Never Leave Handpieces In Sterilizer Over Night. Never use handpieces warm or put under water to cool down. Leave on counter to reach room temperature.

It Is Unnecessary To Re-lube When Using A Synthetic Lube

WEEKLY MAINTENANCE

Flush handpiece with degreaser/cleaner or lube on the intake side of the handpiece(shown above) until solution runs clear through the head.
Spray lube directly into chuck, especially if it is an auto chuck(push button or lever).
Follow above steps 1-5.

LIFE-TIME LUBE BEARINGS

Clean handpieces externally with a degreaser/cleaner.
DO NOT USE LUBE INTERNALLY OR RUN ON A FLUSH SYSTEM! (Cleaners and lube will break down the special grease that is used in the bearing and will void the warranty)